Seko PoolDose pH Manual De Instrucciones página 13

PoolDose | pH · ORP
11. ALARMS
Alarm Display PoolDose pH
TANK Level LOW
Level
Measure out
of range MEASURE TOO HIGH
OFA Alarm
(time > OFA OFA
time)
FIlTRATION OFF
Flow Rate
Error_______4_pH
Calibration
Error_______7_pH
Function
calibrat_____ pH7
System Error
Modbus Error
To restore the default parameters, follow the steps below:
•
Power off the PoolDose unit
•
Keep and
•
The unit will flash
Init.default__Yes
•
Press
•
Press to restore the default parameters.
Default Parameters
Language
Time OFA
Flow Input
Set Point value
Calibration
Dosing Method
Alarm measure:
n
1 Temp. Measure min
2 Temp. Measure Max
3 pH Measure min
4 pH Measure Max
5 ORP Measure min
6 ORP Measure Max
0000138981
MEASURE TOO LOW
(<6 pH)
(>8 pH)
Parameters error
pressed and power on the unit
Init.default__no
Item
Display PoolDose ORP
-
MEASURE TOO LOW
(<600 mV)
MEASURE TOO HIGH
(>800 mV)
-
-
Error_______700_mV
wdg
PoolDose pH
7.4 pH
7 pH / 4 pH (2-point)
Acid
+10°C
+38°C
6 pH
8 pH
+600 mV
+800 mV
rev. 1.0 EN
Actions to do
- Restore Product tank
- Replace or check the
measure probe
- Restore pH / ORP measure
- Push to reset
- Restore Flow Rate
- Restore Probe or Buffer
solution and repeat
calibration procedure
- Press to restore Default
parameter
- Broken Unit
- Press to reset
- Restore communication
PoolDose ORP
EN
OFF
OFF
700 mV
475 mV
Low
Limits
11