Operation Conditions - treston 10149042 Instrucciones De Montaje

ASSEMBLY INSTRUCTION
906016
2019-02-12
5 (9)
GB

OPERATION CONDITIONS

The table can be used in dry indoor conditions only. It must not be exposed to moisture, corrosives, dust etc. (IP20)
ASSEMBLY
Assemble the table according to the assembly instructions. Any unevenness of the floor can be corrected by turn-
ing the adjustment screws in the aluminium table feet.
OPERATION
The permitted loads are shown on the table frame. The table top should be evenly loaded.
MAINTENANCE
The principal parts of the adjustable table need no maintenance. After prolonged driving add some lubrication to
components being rubbed or rolled. All screws under tension should be checked occassionally for tightness.
PARTS REQUIRING LUBRICATION
First loosen the plastic covers on the sides of the feet and the table top.
Lifting screws:
Drive the frame to the height of appr. 70 cm and this will expose through the lower holes at the ends of the stand a
CM6 lubrication nipple (DIN71412). Inject some grease e.g. Mobiltac 81. Drive the frame up and down so that
the whole thread is lubricated. If the frame is driven continually with heavy loads, lubrication should be carried out
ideally once a month at the very least once a year.
Bronze slide bearings:
Through the upper holes the bearings can be seen. Lubricate the bearings with a few drops of e.g. Mobil Vactra 4
oil. The other bearings can be lubricated from above after loosing the steel cover. Lubricate once a year.
Loading:
Loading capacity 200 kg evenly loaded.
If the table must be adjusted several times, we recommend lighter loads.
Dust the top of product regularly with a duster or dampt cloth. Always use the recommemded cleaning equipment
and materials in ESD areas. Since dirt on ESD products can reduce their ESD capabilities, remove dirt from the
wheels regularly.