DOMPEL TOP Manual De Instruccion página 4

Install your Dompel product in a level place with no grooves or splices,
preventing rocking and vibration. The location must be airy and it must not allow
straight sunlight and it must be away from sources of heat (stoves, ovens, etc.)
and flammable products. Do not install your product outdoors.
Do not use metal spatulas, brushes and cleaning agents such as alcohol, acetone, kerosene, gasoline, bleach,
thinner, solvents, varsol, vinegar or other chemicals or abrasives such as sandpaper or steel brushes.
To easily clean it, use a solution of warm water with a neutral soap and then wipe dry carefully. If chemical
products reach the upholstery, clean as soon as possible, preventing the products from staining or drying the
fabric. The plastic parts can not be washed with boiling water. Chromed metal components can be cleaned with a
soft, dry flannel, and silicone-based automotive wax can be used to increase gloss and durability, in this case
perform the task following the wax manufacturer's instructions. Perform periodic cleaning, accumulated dust
affects the beauty of the product making it difficult to clean the product.
Remove all volumes from the package, and follow the steps bellow
IMPORTANT: DO NOT REMOVE THE BASE PROTECTION UNTIL THE END OF THE PRODUCT
ASSEMBLY, IN ORDER TO PROTECT THE FINISHING (PAINT OR CHROME) OF POSSIBLE FALLING
SCREWS OR TIGHTENING KEYS.
1
2
Assemble the hydraulic (F)
on the base (J) using the
washer (M10) and lower
fixing screw (M10 x
25-SX) (H) (the smallest
screw is available in the
screws package). Tighten
with a spanner 17.
4
Manually fasten the
plastic finishing cover
of the backrest
support (M) on the
reclining system or
fixed support (K).
6
Fit the backrest set (B) in the reclining system
or fixed support (K): partially insert the 04
backrest screws (M6 x 30-AB) (E) pre-fixed to
the part, using a 4 mm Allen key. After check
the alignment of the backrest in relation to the
seat and make the final tightening of the
screws.
3
Fit the base / hydraulic set (F)
in the reclining system or fixed
support set (K), using the
washer set (M10) and upper
screw (M10 x 60-SX) (I) (the
biggest screw is available in
the screws package)
with a wrench 17.
IMPORTANT: CHECK THE
SCREW TIGHTNESS
FIRMLY BEFORE
PROCEEDING TO THE
NEXT ASSEMBLY STEP.
5
Assemble the seat set (A) on
the reclining system or fixed
support (K), fitting the 06 screws
(M6 x 30-SX) pre-fixed on the
seat (L), using a wrench 10.
Avoid accidents. After
unpacking the product,
keep all the pack material
out of children's reach.
Fit the handle (G) in the
hydraulic pump (F).
Attention to the correct
assembly position
described on the label
attached to the pump.
Fasten it by tightening
the side screws (M8 x
8-SX INT-SC) using an
Allen key 4 mm.