Installation - Glacier bay HD67108W-6004 Guía De Instalación Y Cuidado

Installation

1
Installing the faucet assembly
CAUTION: Always shut off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
□
Shut off the water supply. Remove the old
faucet.
□
Clean the mounting surface.
□
Remove the preassembled nut (D) and
washers (B & C) from the new faucet (A).
□
WITH NO DECK PLATE:
through the mounting holes in the sink until the
faucet (A) sets on top of the sink.
□
WITH DECK PLATE:
gasket (G) and deck plate (F) with the mounting
hole in the sink. Place the faucet (A) through the
deck plate (F) and mounting hole in the sink until
the faucet (A) sets on top of deck plate (F).
F
G
Place the faucet (A)
A
Align the hole in the
A
2
Securing the faucet
□
Install the plastic washer (B), and metal washer
(C) onto the threaded mounting shank.
□
Thread the nut (D) onto the mounting shank.
Lock the nut (D) into position by tightening the
screws (E). Do not overtighten.
4
A
B
C
D
E