Care And Cleaning; Troubleshooting - Glacier bay HD67108W-6004 Guía De Instalación Y Cuidado

Care and Cleaning

□
To clean, wipe down with a damp cloth and dry with a towel.
□
Do not use abrasive cleaners, steel wool, or harsh chemicals when cleaning this faucet, or the warranty will
be voided.

Troubleshooting

NOTE: Refer to the service parts section in this manual for
a detailed drawing showing the location of the parts listed
below.
Problem
There are leaks from the
handle.
The aerator has an
irregular or reduced
water flow.
The water will not shut off
completely.
There is leaking from the
sink drain at the base of
the sink.
Possible Cause
The bonnet nut has come loose and/or the
washer is dirty or damaged.
The aerator is dirty or mis-fitted.
The cartridge is dirty or broken.
The sink has a rough or irregular surface.
□
□
□
□
□
□
□
□
7
Please contact 1-855-HD-GLACIER for further assistance.
Solution
Use wrench to retighten the
bonnet nut sufficiently.
Clean or replace the washer.
Remove the aerator and
check for debris.
Ensure that the rubber washer
is properly installed.
Remove the handle to check
the cartridge.
Clean or replace.
Apply additional silicone sealant
to the beveled side of the drain
flange.
Retighten and test for leaks.
HOMEDEPOT.COM/GLACIERBAY