Beta 1498/120A Instrucciones página 18

INSTRUCTIONS FOR USE
so that it is always at an optimal level of charge. In this charging phase, the appliance can be left
connected to the battery for several months.
7. If you wish to end or interrupt the charging cycle, follow the charge end/interruption instructions.
INTENTIONAL INTERRUPTION OF CHARGING CYCLE
If you want to interrupt the battery charging cycle, simply press the START/STOP key; the corresponding
LED will switch off to show that the work cycle has ended. Disconnect the output lead of the appliance
from the mains socket and the output leads from the battery terminals.
INTERRUPTION OF CHARGING CYCLE IN CASE OF A POWER SUPPLY CUT
In the case of a 110V – 230V mains power supply cut, the battery charger saves the work cycle it was
performing in order to restore it automatically (only in the FLASH mode) as soon as the 230V power
supply is restored. This feature is fundamental if the battery charger is used to charge batteries without
the operator supervising the cycle; for example, during very long charging cycles. Whereas, in the
CHARGE mode, the START/STOP key must be pressed to resume the work cycle.
END OF CHARGING
1. Once the battery is charged, press the START/STOP key of the battery charger. The LED will turn off
to show that the battery charger has completed the work cycle.
2. Disconnect the power supply lead of the appliance from the mains socket.
3. Disconnect the output lead with the black clamp from the motor vehicle's earthing point or from the
negative terminal (-) of the battery.
4. Disconnect the output lead with the red clamp from the positive terminal (+) of the battery.
After use, replace the battery charger in a dry place free from humidity. To clean the outer casing, use
a dry cloth.
MAINTENANCE
Maintenance and repair jobs must be carried out by trained personnel. For such jobs, you can contact
Beta Untensili S.P.A.'s repair centre.
DISPOSAL
The crossed-out wheelie bin symbol on the equipment or packaging means that the product should be
collected separately from other types of urban waste at the end of its useful life.
Any user who is going to dispose of this tool can:
- deliver it to an appropriate collection facility for electronic or electrotechnical equipment;
- return it to the dealer upon purchase of a new, equivalent item of equipment;
- in case of a product for professional use only, contact the manufacturer which will arrange for the
product to be properly disposed of.
Proper disposal of this product allows the raw materials contained in it to be reused and prevents
damage to the environment or human health.
Illegal disposal of this product is a violation of the provision concerning the disposal of hazardous waste
and will give way to the application of such fines as provided for under current regulations.
WARRANTY
This tool is manufactured and tested in accordance with current EU regulations. It is covered by a
12-month warranty for professional use or a 24-month warranty for nonprofessional use.
We will repair any breakdowns caused by material or manufacturing defects by fixing the defective
pieces or replacing them at our discretion.
18
EN