Publicidad
Idiomas disponibles
Idiomas disponibles
STEP-BY-STEP ASSEMBLY
Step 5
Insert four Short Bolts with Washers
locations shown below and handtighten them. If holes do not align, begin tightening the long bolts inside the case with
an Allen Wrench
4
bolts from Step 2 through Step 5 with an Allen Wrench
With help, Carefully roll the
assembly over so that the
bottom is facing up
as shown.
2
4
through the Cross Rails
2
to draw the Side Frame
into the Cross Rails
C
2
into the Connection Post of the Side Frame
B
. Once all bolts have been inserted properly, tighten all
B
. NOTE: Tighten Evenly. Do Not Over Tighten
4
B
Short Bolt with Washers
(1/4"x5/8")
Allen Wrench
in the
C
C
x4
x1
6/18
8/11
Publicidad
