Eldes ME1 Guia De Instalacion página 7

TRANSFORMER
TRANSFORMER
1 ESIM364/ESIM264 + EPGM1
2
The standard ME1 metal cabinet does NOT contain all of plastic standoffs, the quantity
and the type of which depends on your additionally acquired device
.
Insert the plastic standoffs into the appropriate mounting points and fix the circuit board
of selected device on the holders as indicated above (in pics on page 6 and 7).
In order to appropriately install EPGM1 module, please install it in the first place and
ESIM364/ESIM264 alarm system afterwards. EPGM1 must be mounted on shorter plastic
standoffs, while ESIM364/ESIM264 and ELAN3-ALARM – on the longer ones. The
mounting points of EPGM1 module and ESIM364/ ESIM264 system are indicated above.
You also may wire up the accessories, such as keypads, zone and PGM output expansion
modules, ELAN3-ALARM module, temperature sensors. If you choose to install the
buzzer, it must be closer to iButton key reader in order to hear the exit delay countdown.
ME1 METAL CABINET EN 7