Classic Accessories 79507 Instrucciones

Instructions: Pressure Washer Cover
WARNING!
Do not operate the pressure washer with the cover on.
CAUTION!
Let your pressure washer cool before you put the cover on.
Fitting
Your Pressure Washer Cover fits vertical or horizontal style pressure washers up to 48
in. L x 18.5 in. W x 13.5in. H. Note: This cover may not cover the spray wands on some
pressure washers.
Installation
Check your horizontal or vertical pressure washer for sharp objects or corners that
can stress your cover. Make sure the hose and spray gun are secure, as these items
could damage your cover. Slip your cover over the top of your horizontal or vertical
pressure washer, with the Classic logo to the front, then pull the cover down on all four
corners. To insure a snug fit, once you have the cover into place, connect the click-it
buckle located behind the handlebar. (Fig. 1)
Use and Storage
Your Pressure Washer Cover has an integrated storage bag. To fit your cover in the bag fold and roll it
tightly rather than stuffing it. Never store a wet cover in the storage bag or confined area as the cover can
be damaged by mildew.
Cleaning and Care
Clean your cover with a soft brush and luke-warm water. DO NOT USE SOAP as it may remove the
protective coatings added by the factory. Air dry.
CLASSIC ACCESSORIES, INC., KENT, WA USA 98032
©2012 c l a s sic a cce s s o r ie s .c o m
Fig. 1
79507, 78603000
12cH54_13096
do not do not
use soap
pack wet
do not iron no bleach
line dry water
resistant
no tools
required