Budda BULLY Manual De Instrucciones página 27

BULLY™ GUITAR AMPLIFIER
MASTER SECTION
(33) Boost
This sets a user definable volume boost that can be applied to any of the three channels and can be
turned on and off using the footcontroller. This is extremely useful when you need a boost in volume for
solos, as you don't have to dedicate a particular channel for that use.
The control has been calibrated so that the mid point setting gives a +6dB boost and on full gives +10dB.
(34) Volume
This sets the overall level of the amp. Once the desired balance between the three channels has been
set using their own Volume controls, the entire level of the unit can be increased or decreased by
adjusting this control. A good policy to avoid unwanted and possibly damaging loud sounds is to turn
this control to minimum before turning the unit on. However it can be left set to the required stage
volume and Standby switched to "Off" during breaks, therefore ensuring the correct volume level
when returning to the stage.
(35) Power Switch
This two-way toggle switch applies mains power to the unit. Down is off, up is on.
Before switching on, check that the Standby is in the "Off" position.
(36) Power Status Lamp
This indicator illuminates when mains power is being applied to the amp.
(37) Standby Switch
This two-way toggle switch allows the amp to be placed in Standby mode, where the amp can warm up
or remain warmed up, before switching up to the fully active mode. Down is Standby, up is fully on.
Always have this set to Standby when first switching on the Power switch. Then allow the
amp to warm up for at least one minute before switching out of Standby.
Also, at the end of use, try to switch this off at least a few seconds before turning the Power switch off.
This prevents any unwanted noise.