Toparc RC-HA2 Manual Del Usuario página 4

WARNING - SAFETY RULES
GENERAL INSTRUCTIONS
Read and understand the following safety recommendations before using or servicing the unit.
Any modification or servicing that is not specified in the instruction manual must not be undertaken.
The manufacturer is not liable for any injury or damage due to a non-compliance with the instructions featured this manual.
In the event of problems or doubts, please consult a qualified person to handle the installation properly.
OPERATION
This remote control is designed to work with MIG / MAG welding processes. It can remotely set the wire speed (button n°1, fig 1) and the welding
voltage about the station (button n°2, fig 1). For further details, check the wire feeder's manual.
Compatible machines : NEOFEED/PULSFEED, EXAFEED/GENFEED, NEOPULSE/PULSEMIG 320 C
SUPPORT INSTALLATION
The analogue remote control support can be fitted on the trolley (option, ref. 037328).
M6x16 (x2)
1
WARRANTY
The warranty covers faulty workmanship for 2 years from the date of purchase (parts and labour).
The warranty does not cover:
• Transit damage.
• Normal wear of parts (eg. : cables, clamps, etc..).
• Damages due to misuse (power supply error, dropping of equipment, disassembling).
• Environment related failures (pollution, rust, dust).
In case of failure, return the unit to your distributor together with:
- The proof of purchase (receipt etc ...)
- A description of the fault reported
4
RC-HA2
2
EN