Displays; Imprint; Important Notice - Resol Smart Display SD3 Instrucciones

Smart Display SD3
Note:
When several additional modules are used simultaneously, an
additional power supply of the modules might possibly be re-
quired.
3.

Displays

Important notice:

We took a lot of care with the texts and drawings of this
manual and to the best of our knowledge and consent. As
faults can never be excluded, please note: Your own calcu-
lations and plans, under consideration of the current stan-
dards and DIN-directions should only be basis for your
projects. We don´t offer a guarantee for the completeness
of the drawings and texts of this manual - they only repre-
sent some examples. They can only be used at your own
risk. No liability is assumed for incorrect, incomplete or
false information and the resulting damages.
8
|
VBus terminal
The Smart Display SD3 can be operated in parallel with a
controller and additional modules via a bus line.
Connect the connection cable with stripped ends and
any polarity to the VBus
SD3.
Pass cable through strain relief.
During commissioning, the Smart Display SD3 carries out
an initialising phase. After this test the following indications
are shown:
• SD3 in the upper display
strain relief
• Software version in the display in the middle
• Date of software version (YYMMDD) in the lower dis-
play
Afterwards, the SD3 receives data packets from the cont-
roller. The progress is indicated in the lower display.
Afterwards, the SD3 is ready for normal operation.
Note:
If no indication is shown in the display, please check the connec-
tion at the VBus
Collector temperature in °C.
Store temperature in °C.
Energy yield in kWh.
Reprinting / copying
This mounting- and operation manual including all parts is
copyrighted. Another use outside the copyright requires
the approval of RESOL - Elektronische Regelungen GmbH.
This especially applies for copies, translations, micro fi lms
and the storage into electronic systems. Editor: RESOL -
Elektronische Regelungen GmbH
Please note:
The design and the specifi cations are to be changed without
notice.
The illustrations may differ from the original product.
B
-terminals at the rear side of the
®
® terminals.