Step-By-Step Instructions - Dentsply Sirona ProMix 2 Manual De Instrucciones

5

Step-by-step instructions

5.1 Setting the mixing timer
NOTE: The cycle time will be illuminated in red figures on the front of the ProMix™2.
1. Place the protective lid of the ProMix™2 down, set the desired mixing time by
pressing the 'seconds' button
2. Press the 'Start/Pause' button
3. At the end of this cycle, the selected time is now set as the cycle time.
WARNING: When opening the cover, do not attempt to touch the mixing forks until they
have stopped.
5.2 Placement of capsules
1. Lift the protective lid and insert the capsule into the capsule mixer fork.
NOTE: Capsules with the extended tips (e.g. ChemFil
with the tip facing to left.
2. Lower the protective lid.
5.3 Start/Pause/Stop
1. Press the 'Start/Pause' button
2. To pause mixing, press the 'Start/Pause' button. Pressing the 'Start/Pause'
ton again will continue the paused mixing cycle.
3. To stop mixing, lift the protective lid. After closing the lid again, pressing the 'Start/
Pause' button
cover, do not attempt to touch the mixing forks until they have stopped.
4. At the end of each day, it is recommended to turn off the capsule mixer with the
switch at the rear of the unit.
Timer
. NOTE: Timer operates from 1 to 16 seconds.
to start mixing for the selected duration.
to begin mixing.
will start a new full mixing cycle. WARNING: When opening the
Start/Pause
sec.
Increase Time
Rock) should be inserted
®
ProMix™2
but-
5