AVS Aeroskin Instrucciones De Instalación página 3

Installation Steps
7
Begin removing remaining tape liner, beginning with the drivers side CENTER TOP . Grasping the free end, pull tape gently in 6" (15 cm)
sections, while applying even pressure with hand to Aeroskin. Repeat process for passenger side.
8
NOTE: Do not apply pressure closer than 6" (15 cm) to tape liner as it could accidentally break.
Using the same process, remove tape liner from the driver side CENTER BOTTOM of hood skin. Repeat for passenger side.
9
Again using the same process, remove tape liner from the driver side FAR SIDE EDGE of Aeroskin. Repeat for passenger side.
10
NOTE: Actual application may vary slightly from illustrations.
Center the Aeroskin on the hood.
Page 3 of 4
CAUTION: You must apply even
pressure from center section out to
each end of part, in order for proper
adhesion to hood.
CAUTION: You must apply even
pressure from center section out to
each end of part, in order for proper
adhesion to hood.
NOTE: Some applications do not
have side tape by design.