Park Tool CWP-7 Instrucciones

PARK TOOL CO.
5115 Hadley Ave. N., St. Paul, MN 55128 (USA) www.parktool.com
CWP-7 Compact Crank Puller
The CWP-7 is a compact crank puller that can be
used to remove most square taper cranks, as well
as splined Octalink and ISIS Drive cranks.
®
Instructions:
1. Remove crank bolt and washer using proper
wrench.
2. Two rotating tips are included with the CWP-7,
one on each end of the driver. When removing
square-hole cranks, install 11.3mm tip onto
threaded end of driver. When removing
splined-hole cranks, install 16.3mm tip onto
CWP-7 PART NUMBERS
Ref. # Part # Description
1 961 Stud with O-Rings
2 1202 Swivel Foot
1203 Swivel Foot
3
4 1206 Hex Nut
5 1625-2 O-Ring
12/16
CWP-7
Instructions / Instructions / Anleitung / Instrucciones
threaded end of driver. These tips are easy to
remove and install — simply pull tip to remove
and press firmly onto driver to install.
3. Thread nut completely onto driver. Insert
driver into hole of crank until rotating tip
contacts bottom bracket spindle.
4. Thread nut into crank and tighten until
snug (use a wrench if necessary). Note:
Crank threads may be damaged if nut is not
completely threaded into crank.
5. Turn driver clockwise with 15mm wrench or
adjustable wrench until resistance is felt.
Continue turning handle until crank is removed.
4
Qty.
1
1
1
1
2
2 5 1
PARK TOOL® and the color BLUE are registered trademarks of Park Tool Co.
11.3mm Tip
Nut
Driver
16.3mm Tip
5 3
© 2016 Park Tool Co.