Velleman HQ-Power VDL60FE Manual Del Usuario página 2

- Use an appropriate safety cable to fix the device (e.g. VDLSC7 or VDLSC8).
- Familiarise yourself with the functions of the device before actually using it. Do not allow operation by unqualified
people. Any damage that may occur will most probably be due to unprofessional use of the device.
- Use the original packaging if the device is to be transported.
- All modifications of the device are forbidden for safety reasons.
- Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks, lamp
explosion, crash, etc. Using the device in an unauthorised way will void the warranty.
4. Installation
a) Lamps
- Only fit or replace a lamp when the device is unplugged from the mains.
- Let a lamp cool down before replacing it as the temperature of a lamp can reach 700°C during operation.
- Do not install lamps with a higher wattage. They get hotter than the ones this device was designed for.
- Replace a deformed or damaged lamp with a lamp of the same type. For this device you need a set of 3 coloured
lamps (LAMPBLFE: 1 blue and 2 amber ones; see "Technical Specifications"):
1. Carefully remove the silk cloth and gently remove the lamp(s) to be replaced from the socket(s).
2. Insert the new lamp(s), making sure the blue lamp is in the middle and the amber ones on the outside.
3. Replace the silk cloth.
b) Fuse
- Only fit or replace a fuse when the device is unplugged from the mains.
- If a lamp burns out, chances are you will need to replace the fuse as well.
- Replace a blown fuse with a fuse of the same type and rating (see "Technical Specifications"):
1. Unscrew the fuse holder inside the bowl with an appropriate screwdriver.
2. Remove the old fuse and install a new one.
3. Replace the fuse holder and fasten it with the screwdriver.
c) Mounting the Device
- Have the unit installed by a qualified person, respecting EN 60598-2-17 and all other applicable norms.
- The construction to which the device is attached should be able to support 10 times the weight for one hour without
deformation.
- The installation must always be secured with a secondary attachment e.g. a safety cable.
- Never stand directly below the device when it is being mounted, removed or serviced. Have a qualified technician
check the device before you bring it into service. Have a qualified technician check the entire installation once a
year.
- Install the device in a location where nobody can pass by, sit down or touch it.
- Overhead mounting requires extensive experience: calculating work load limits, determining the installation material
to be used... Have the material and the device itself checked regularly. Do not attempt to install the device yourself
if you lack these qualifications as improper installation may result in injuries.
- Make sure there is no flammable material within a 0.5m radius of the device.
- Have a qualified electrician carry out the electric connection.
- Connect the device to the mains with the power plug. Don't connect it to a dimming pack.
- The installation has to be approved by an expert before the device is taken into service.
5. Use
Switch the unit on and off by means of the power switch. Do not operate the unit continuously.
VDL60FE 2 VELLEMAN