NOTE: Before assembly, to avoid being locked
out of cabinet, remove the key for manual
entry from the battery compartment on the
back of the electronic lock.
ASSEMBLING CABINET
1. Place the back (1) on a protected surface. The
bottom flange should face upward. Bolt panels
together using seven bolts and nuts, with nuts on the
inside of the unit. (See Figure 1)
Figure 1
BOTTOM
NOTE: When bolting the unit together, leave
the bolts slightly loose until step 7, unless
otherwise specified.
2. Attach the left side (3) to the back by placing
flange around the back and bolting the back and
sides together. Be sure that the shelf supports on all
shelf adjustment strips point up on both back and
side. (See Figure 2)
Figure 2
1
PAGE 3 OF 15
1
TOP
3
ASSEMBLY
3. Attach the top (4) to the unit by sliding the outer
flange over the back of the unit and the side flange
on the top over the side panel. The threaded studs
should go through the holes in the top flange of the
side and fasten with three nuts. Attach the back to
the top using four bolts and nuts. (See Figure 3)
Figure 3
4. Attach right side (2) in the same manner used in
step 2. Make sure the side flange overlaps the back
panel and the flange on the top is over the right
side. Push the side panel up so the studs in the top
go through the holes in the top flange of the side.
Fasten with three nuts. (See Figure 4)
Figure 4
3
1
3
Threaded studs
go through the
holes in the
flange at the
top of the side.
4
1
2
1120 IH-6314