Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
5. Attach the sill (8) to the sides. Place nuts loosely on
each of the studs and slide the ends of the sill into
the slots on both sides of the unit. Then securely
tighten with nuts. (See Figure 5)
8
Slide studs into the slots located near
the bottom of each side panel.
6. Place a shelf (5) into the four lowest shelf supports in
the back. The front of the shelf will rest on the sill.
(See Figure 6)
5
8
FRONT
Override Key
Cover Plate
PAGE 4 OF 15
ASSEMBLY CONTINUED
ELECTRONIC LOCK INSTRUCTIONS
Main Display
OPEN
11
11
11
11
11
11
11
01:52
*
1
2
3
4
5
6
0
7
8
9
#
Handle
Keypad
7. Using two people, set unit upright and tighten all nuts
and bolts. Insert the remaining shelves. Be sure the
shelf edge with no slots faces the cabinet front. The
slots on the other three sides fit over the shelf supports
on the cabinet walls, which hold the shelf in place.
Figure 5
NOTE: To ease shelf installation, have second
person apply slight pressure to the back panels
from behind the cabinet, while other person
installs shelves.
8. Attach the left door (6) to the unit. Place the door on the
hinges, align the holes and drive four hinge pins (9)
into place. (See Figure 7)
Figure 6
9. Repeat step 8 for the right door (7).
NOTE: If having issues with doors aligning, it
may be due to cabinet not sitting level. Use
included nut driver to adjust leveling feet in
bottom front two corners. Nut driver should
insert through inside of cabinet down into feet
and adjust as needed.
10. Adjust the levelers underneath the front of the unit to
ensure the cabinet is leveled.
NOTE: The doors will not align properly if the
cabinet is not leveled.
Date and Time
Display
9
6
BACK
Reset
Button
Battery
Compartment
Figure 7
7
1120 IH-6314
Publicidad
Tabla de contenido
