Team kalorik TKG SIS 1002 Manual De Instrucciones página 11

Fax +32 2 359 95 50

Do not use the iron if it has fallen, if it shows any visible signs of damage or if it leaks.

When you place the iron on its support (if available with the model), make sure that the

surface on which you put the support is stable.
Proceed the same way if the water tank stops working or is damaged. To avoid the risk of

electric shock, do not disassemble the iron or steam tank, take it to a qualified technician
for examination and repair. Incorrect re-assembly can cause a risk of electric shock when
the iron or steam tank is used.
Fully unwind the main cord and supply hose before starting to iron.

The power switches should always be put in the off-position ("0") before plugging or

unplugging the power cord from outlet.
Unplug the appliance and allow the iron and the water tank to cool down before

cleaning or storing them and for pressurized steam iron station (depending on the model)
before opening, filling or emptying the water tank.
FOR PRESSURIZED STEAM IRONING STATION (DEPENDING ON THE MODEL), NEVER OPEN THE

CAP OF THE STEAM TANK WHILE THE APPLIANCE IS CONNECTED TO THE MAINS WALL SOCKET
AND ESPECIALLY WHEN STEAM IS BEING PRODUCED.
(*) Competent qualified service: after-sales department of the producer or importer or any
person who is qualified, approved and competent to perform this kind of repairs in order to
avoid all danger. In case of need you should return the appliance to this service.
BEFORE THE FIRST USE
 We recommend cleaning the iron before the first use as follows: fill the water tank, plug in
the appliance, press the boiler power switch and the iron power switch, put the
temperature dial on position "LINEN" and the steam regulator on MAX and let the iron
heat for 10 minutes. When the temperature has been reached, take the iron from the
base, hold it vertically and keep the steam button pressed for 30 seconds, then wait 30
seconds and repeat this cycle twice.
 Switch off the appliance (boiler power switch and iron power switch in the off-position
"0"), unplug it and let it cool down sufficiently, then clean the soleplate with a damp
cloth.
STEAM IRON: PRECAUTION FOR USE AND TEMPERATURES
 Always check first if a label with ironing instructions is attached to the article that needs to
be ironed. Follow these ironing instructions in all cases.
 If ironing instructions are missing but you know the kind of fabric, then see the table for
recommended ironing temperatures.
Kind of textile
Nylon
Synthetic (e.g. acetate,
acrylic, viscose,
polyamide, polyester, ...)
Silk
Wool
Cotton
Linen
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
Temperature dial
MIN









MAX
11
Assembly page 11/64
Steam ironing
NO
YES
YES
TKG SIS 1002 - 130424