Draw-Tite Hide-A-Goose RAM 2500 Instrucciones De Instalación página 4

VEHICLE - FORWARD
Vehicle and Box Centerline
AFTER SYSTEM INSTALLATION AND BEFORE TOWING:
Connect trailer to the tow vehicle following coupler manufacturer's operating instructions. The coupler
must be adjusted to provide about 6" of clearance between the bottom of the trailer nose and the top of the
pickup bed sides. Slowly back the trailer to a jackknifed position to the tow vehicle while checking to see
there is adequate clearance between the gooseneck trailer and the rear of the vehicle. Also check to see
there is adequate clearance between the forward corners of the gooseneck trailer and the cab of the truck.
Slowly jackknife the truck and trailer in the opposite direction and check the clearances to the end of the
truck and the cab.
GOOSENECK MAINTENANCE:
Use cover/plug to keep assembly free of dirt and debris. Lubricate hitch ball monthly or as needed with
heavy grease. Lubricate ball sleeve with heavy grease when ball is installed and/or removed. Check that
hitch ball is locking properly in hitch sleeve before every time you tow. Do not leave hitch ball in hitch
when not towing. Check bolt torque monthly. Check equipment before towing for worn or damaged parts.
REPLACE WORN OR DAMAGED PARTS IMMEDIATELY.
© 2020 Horizon Global Americas Inc.
Hide-A-Goose
Installation Instructions - RAM 2500/3500
3-⅜" DIA.HOLE
Figure: 3
TM
38-7/8" (6'4" BED)
40-7/8" (8'0" BED)
Page 4 of 13 9485N
Part Number:
9485
Rear edge of truck box
Floor stiffeners
6/2/20 Rev. A