Symmons 1003-GSH-14 Manual De Operaciones Y Mantenimiento página 3

Installation
1) Measure and mark drill hole
locations according to the
dimensions provided. Drill 5/16"
(8 mm) holes into wall.
2) Insert four toggle anchors (D, F)
into drill holes. Install two screws (E)
into two toggle anchors (D), leaving
1/16" (1.5 mm) from the end of
the screw head to the wall.
E
D
H
*Note: For plaster walls 1/2" thick
or less, insert toggle tool (H) into
toggle anchors (D, F) to secure
behind wall prior to installing trim.
3) Install rail (A) into bracket slots (G).
Note: Ensure rail sits level in slots
before moving to step 4.
4) Attach back plates (B) to
mounting brackets (G). Secure
back plate with screws (C).
D
5) Hang mounting brackets (G) onto
two screws (E). Lower accessory
into position.
F
F
Note: If brackets (G) hang too
loose, thread screws (E) deeper into
toggle anchors to provide tighter fit.
A
G
C
B
G
E
3
6) Install two screws (I) to mounting
brackets (G) to secure accessory
to wall.
I
7) Insert glass panel (K) into mount-
ing brackets (G). Using phillips
head screwdriver, secure with two
screws (J).
G
J
K
G
J
2