Publicidad
Idiomas disponibles
Idiomas disponibles
Adjustment of electronic thermostatic mixer. (motor alignment)
Hansgrohe has set the electronic thermostat at 38 degrees Centigrade.
(water pressure 3 bar, Dt 50 degrees Centigrade).
Check the following points before adjusting the electronic thermostat to correspond with local
specifications:
Warning:
Before adjusting thermostat check the following points:
- Power supply 230 V / 50 Hz (control the fuses).
- Check that the hot water heater is on.
- All showers must be turned off.
- The hand shower is being turned on automatically.
Adjustment of comfort control system II:
1. Push the savety key
display flashes.
2. Using the "+" and "-" keys set display at 1.1C.
3. Push light key
4. The semi-automatic motor alignment is now activated.
The alignment takes about 3 minutes. During this time the respective temperatures are
displayed. On completion 1.1C wil again be shown in the display.
Flashing displays showing 11.1C; 21.1C and 31.1C are error messages which make it
necessary to repeat the procedure from point 3.
This malfunktion could have several reasons; fluctuating cold and hot water supply to the
thermostat, or shifting water pressures during the adjusting process.
5. Push Safety key
Typing error:
Should you make an error during programming, press the Safety key twice to cancel all
7
and the light key
.
. (save, end of program)
English
simultaneously and keep them depressed until the
Publicidad
