Environmental Protection - Worx Professional WU700 Manual Del Usuario

Working hints for your angle
grinder
If your power tool becomes too hot, run no load for 2-3 minutes to
cool the motor.
Never start your angle grinder with the disc/ accessory in contact
with the workpiece.
Always start at no load to achieve maximum speed then start
working.
Do not force the disc to work faster, reducing the Disc's moving
speed means longer working time.
When grinding, always work with a 30° to 40° angle between disc
and workpiece. Larger angles will cut ridges into the workpiece and
affect the surface finish. Move the angle grinder across and back and
forth over the workpiece.
When using a cutting disc never change the cutting angle otherwise
you will stall the disc and angle grinder motor or break the disc.
When cutting, only cut in the opposite direction to the disc rotation.
If you cut in the same direction as the disc rotation the disc may push
itself out of the cut slot.
When cutting very hard material best results can be achieved with a
diamond disc.
When using a diamond disc it will become very hot. If this happens
you will see a full ring of sparks around the rotating disc. Stop cutting
and allow to cool at no load speed for 2-3 minutes.
All manuals and user guides at all-guides.com
13
Always ensure the workpiece is firmly held or clamped to prevent
movement.
Maintenance
Remove the plug from the socket before carrying out any
adjustment, servicing or maintenance.
Your power tool requires no additional lubrication or maintenance.
There are no user serviceable parts in your power tool. Never use
water or chemical cleaners to clean your power tool. Wipe clean with
a dry cloth. Always store your power tool in a dry place. Keep the
motor ventilation slots clean. Keep all working controls free of dust.
Occasionally you may see sparks through the ventilation slots. This is
normal and will not damage your power tool.
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in order
to avoid a hazard.

Environmental protection

Waste electrical products should not be disposed of with
household waste. Please recycle where facilities exist. Check
with your local authorities or retailer for recycling advice.