Packaging Material; Technical Data - Euromate Dust Free Industrial 8500 Instrucciones Para El Uso

General use
WARNING
Fire hazard! Never use the product for the extraction of
inflammable, glowing or burning particles, substances or
liquids. Never use the product for the extraction and/or
filtration of aggressive vapours (such as hydrochloric acid) or
sharp particles.
• Inspect the product and check for damage. Verify the operation of the
safety provisions.
• Check the workspace. Do not allow unauthorised persons into the
workspace.
• Use your common sense. Stay alert and concentrate on the work. Do
not use the product if you are tired or under the influence of drugs,
alcohol or medication.
• Always ensure adequate ventilation, especially in smaller areas.
• Never install the product in front of entrances, exits and passages
intended for emergency services.
• Ensure that sufficient approved fire extinguishers are available in the
workplace.
• Protect the product from water and moisture.
• Do not use the product at a relative humidity above 80%.
• Do not use the product at temperatures below 5 °C or above 45 °C.
• Keep the controls free of dirt and grease.
• The product is not explosion-proof. Therefore, never use the product in
an explosion-hazardous environment, due to possible sparks from the
motor or the filter package.
Use of DUST FREE INDUSTRIAL 8500
• The product is suitable for extraction and filtration of dust and fine
particulates, cement, sawdust or wood dust etc.
• Never use the product for the extraction of dust particles generated
during welding work on primed surfaces.
• Never use the product for the extraction and/or filtration of vapours
from or produced during:
- gouging
- paint mist
- hot gases (continuously above 40 °C)
- corrosive gases (e.g. from acids)
- plasma cutting
- aluminium or magnesium grindings
- wire flame spraying
- burning cigarettes, cigars, oily rags or other burning particles,
objects and acids
-in all explosion-hazardous situations (this list is not exhaustive)
• After switching off the motor, wait approx. 10 seconds before removing
the filters.
8
Service, maintenance and repairs
In this manual, a clear distinction is made between service,
maintenance and repair work that may be carried out by the
user and that which may only be carried out by trained and
authorised service technicians.
• Switch off the machine for maintenance.
• Observe the specified maintenance intervals. Overdue maintenance
may result in high repair and overhaul costs and may invalidate
warranty claims.
• Always use manufacturer-approved tools, parts, materials, lubricants
and service techniques. Never use worn tools and do not leave any
tools in or on the product.
• Do not carry out any service, maintenance or repair work on the
product until it has been secured against unintentional operation.
• Safety provisions that have been removed for service, maintenance or
repair purposes must be installed and checked for correct operation
immediately after these operations.
• Regularly clean the inside of the housing.
• Replace the filters on time.
4

PACKAGING MATERIAL

VERPAKKINGSMATERIAAL
The packaging used to transport and protect the product
consists mainly of the following recyclable substances:
- solid and corrugated cardboard
- polythene film
- untreated wood
Therefore, do not dispose of the packaging as industrial waste.
Instead, ask your municipal waste management service where
you can submit the material.
Product
Products you dispose of may still contain valuable substances and materials.
Therefore, do not dispose of the product as industrial waste. Instead, ask the
municipality about the possibilities for reuse or environmentally friendly
processing of the material.
5

TECHNICAL DATA

5.1 Technical data DFI 8500
Max. capacity
Filter surface area
Weight
Filter efficiency
Main filter
Pre-filter and final filter
Enclosure
DUST FREE INDUSTRIAL 8500
5000 m /h
3
9,2 m (compact filter)
2
6,3 m (bag filter)
2
140 kg
Depends on filter class
User's choice
User's choice (see product data sheet)
Polyethylene (PE)