Tabla de contenido
Publicidad
IMPORTANT: For connection by
means of Serial-Touch, use only a
cable as shown in the attached
layout (Fig. 30).
Use of any other type of cable may
damage the equipment.
OSD keypad
XM7xx – Fig. 18
A) Allows the automatic regulation of the
monitor.
B) Allows you to display the menu /
Confirm selections.
C) Allows you to move within the on-
screen menu / To decrease the value.
D) Allows you to move within the on-
screen menu / To increase the value.
E) Turning on the Monitor.
Installing the XM
XM712 – Fig. 4
XM715 – Fig. 8
XM717 – Fig. 12
XM719 – Fig. 16
To anchor the cables, insert the
provided bands in the appropriate holes
(Fig. 19).
Power supply
Fig. 20 - Power connector pin-out.
Fig. 21 - Recommended power
connection.
Fig. 22 - Warning: These two
configuration will seriously damage
components.
IMPORTANT:
The
devices connected to the serial
and/or parallel communication ports
MUST have the same potential as the
0V supply of the XM. The circulation
of current between the 0V supply
and the earth of the communication
ports could cause damage to certain
components of the XM or of the
devices connected to it.
earth
of
the
Working temperature
0 / +50°C
Entering set-up parameters
a. Carry out all connections with the
monitor off.
b. Start up PC.
c. Start-up the monitor.
d. Load touch screen drivers.
e. Check that XM has been set with
resolution of:
! XM712 – 800x600
! XM715 – 1024x768
! XM717 – 1280x1024
! XM719 – 1280x1024
Communication ports
Fig. 23 . 24 . 25 . 26 . 27 . 28 . 29
Cleaning
For cleaning the XM we recommend
Denaturalised Ethyl Alcohol.
Certifications
All the products described in this
manual comply with the following
standards:
electromagnetic compatibility (EMC):
!
emissions EN 61000-6-3 (2007)
!
immunity EN 61000-6-2 (2005)
and thus are in line with:
Council Directive
EMC 2004/108/EC
Publicidad
Tabla de contenido
