ShelterLogic 70615 Manual De Usuario página 7

6. InsTAllInG coVeR And coVeR RAIls
A. Your greenhouse cover comes in one complete piece. You may find it easier to fit the cover over the frame by
partially opening the door zippers.
B. Pull cover over the frame, making sure to center cover on frame. There should be an equal amount of over-
hang at all four corners.
C. Inside the greenhouse, place a bungee cord fastener through each grommet hole and loop around the pipe of
the roof frame. Secure elastic around ball.
D. Disassemble cover rails and slide them through the fabric pockets at each leg. Reattach with clamps to each
leg. Repeat this on other side. Push down on cover rails to tighten cover, before tightening bolts completely.
E. Check and tighten Cover Rails monthly to ensure the cover is tight.
A
B
End Rib Cross Rail Clamps
802864
13202
01011
07000
d
Middle Rib Cross Rail Clamps
802864
10115
802695
802695
07000
c
13201
10115
802695
01011
Page 7
Inside view of Cover
05_70615_0B