Uline H-4618 Instrucciones página 2

CAUTION! Misuse can cause electrical shock
and injury.
• DO NOT use as work surface. NO CUTTING, NO
DRILLING, NO HAMMERING.
• Use with momentary loads only. DO NOT place
ladders, scaffolds or any type of structure on the
protector.
• Avoid concentrated loads.
• Use only on a stable surface. Inclined surfaces,
slippery surfaces and broken ground can cause
injury.
• This protector can be a trip hazard to pedestrian
traffic if they are unaware of its presence.
• Keep the 5 Channel Cable Protector clean and
bright.
• Keep various services, communications, fluids and
power separated. Limit a channel to one service
type.
• Polyurethane is attacked by some chemicals. Always
test a small amount for chemical compatibility
before using and follow maintenance procedure.
• Vehicular traffic must pass over the protector slowly
and with caution.
PAGE 2 OF 6
INSTRUCTIONS CONTINUED
MOUNTING INSTRUCTIONS FOR TEMPORARY USE
MAINTENANCE
1-800-295-5510
uline.com
NOTE: Due to variables associated with
mounting, it is highly recommend you test the
hardware for each application
• Four through-holes with an inside diameter of .21"
can be used with either nails or screws (not included)
for temporary mounting of cable protector.
• Washer with a minimum outside diameter of .75"
should be used with each nail or screw.
• Through-holes have a threaded insert, but the
threaded insert is not designed for use with a bolt.
• When temporarily mounting on a sloped surface, the
hinge barrel must be on the uphill side of the slope.
• When temporarily mounting on a flat surface, the
hinge barrel must be facing the direction of traffic.
• To easily remove the protector when nailed down,
use a pry bar in the pry slots under each through-
hole.
• Store in a clean dry area.
• Inspect protector for damage and replace it if
damaged.
• Remove any foreign materials, solids and liquids.
• Keep clean by using a detergent and water solution.
0421 IH-4618