Electrical Connection; Operating Your Electric Bottle Cooler; Care And Maintenance - Saivod VS2814 Manual De Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

 Before connecting the appliance to the power source, let it stand upright for approximately 2
hours. This will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
 Clean the interior surface with lukewarm water using a soft cloth.
 Place your appliance on a floor that is strong enough to support the appliance when it is fully
loaded. To level your appliance, adjust the front legs at the bottom of the appliance.
 Foe recedes installation away from direct sunlight and sources of heat (stove, heater, radiator,
etc.).Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Extreme cold or hot ambient temperatures may also cause the appliances not to
perform properly.
 Not designed for placement in adage or basement. Designed for use inside the home.

ELECTRICAL CONNECTION

WARNING: Improper use of the grounded plug can result in the risk of electrical shock. If the power cord
is damaged, have it replaced by an authorized Products service center.
This unit should be properly grounded for your safety. The power cord of this unit is equipped with a 2-pin
plug which mates with 2-pin wall outlets to minimize the possibility of electrical shock. Do not under any
circumstances cut or remove the ground wine from the power cord supplied.
Use of extension cords is not recommended.
This unit requires a standard 220V-50HZ electrical outlet with 2-pin plug.
The cord should be secured behind the electric bottle cooler and not let exposed or dangling to prevent
accidental injury.

OPERATING YOUR ELECTRIC BOTTLE COOLER

It is recommended that you installed the electric bottle cooler in a place where the ambient temperature
is between 10-26℃(50- 80°F) .If the ambient temperature is above or below recommended temperatures
, the performance of the unit may be affected. For example, placing in extreme cold or hot conditions
may cause interior temperature to fluctuate. The range of 10-16℃(50-60°F )may not be reached.
The temperature may fluctuate depending on whether or not the interior light is on or off or whether the
bottles are located on the upper, middle or lower section.
How to use the press-buttons on the Display Panel:
You can set the temperature as your desire by pressing the button. There are three press-button on the
panel " " and " " to adjust the temperature by 1℃ among 12-18℃(54-66 °F).
You can tune the interior light on or off by pressing the "Light" button.

CARE AND MAINTENANCE

Cleaning your electric bottle cooler
 Unplug the electric bottle cooler and remove the bottles.
 Wash the inside with a warm water and baking soda solution. The solution should be about 2
tablespoons of baking soda to a quart of water.
 The outside of electric bottle cooler should be cleaned with mild detergent and warm water.
 Draw out the water box at the bottom, and wash.
20
VS2814.indd 20
8/18/2016 5:06:03 PM

Hide quick links:

Publicidad

Tabla de contenido
loading

Tabla de contenido