Troubleshooting Guide - Muse M-1229 DAB Manual De Instrucciones

Radio para coche reproductor de cd/mp3 con bluetooth y usb / micro sd
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 30
Answer/ Reject a call/ Redial
When there is incoming call, the phone number appears on display.
Press
to answer a call, the talking time will appear on the display. Rotate volume knob to
adjust the BT VOL.
Press
to reject a coming call.
To redial the last number retained in the memory of the mobile phone, press and hold the
button 4 seconds.
Transfer the call between mobile phone and the unit
During the talking mode, you can press TRANS button to transfer the phone call between the
mobile phone and the unit. When making an outgoing call, it's not possible to transfer if the call
is not being answered yet.
BLUETOOTH AUDIO
The unit supports Bluetooth audio function. If your mobile phone can play stereo music, when
pairing successful, press MODE to access Bluetooth audio mode, "BT MUSIC" appears on
display. The audio file in your mobile phone starts to play via the car radio.
Play/pause: Press
to suspend momentarily the playing track. Press again to resume playback.
Skip to next or previous track:
1. Press
to skip forward to next track.
2. Press
to play the previous track.
Notes:
- This system will not operate or may operate improperly with some Bluetooth mobile phones/
audio players.
- There are many mobile phones in the market. We cannot guarantee the compatibility of all
mobile phones together with the unit.
- If you found the conversation is not clear, try to move closer to the microphone.
Hereby, NEW ONE S.A.S, declares that this MUSE M-1229 DAB is in compliance with the
essential requirements and other relevant provisions of Directive 2014/53/EU. The declaration
of conformity may be consulted at www.muse-europe.com
MAINTENANCE
Precaution
- Clean the front panel with a soft cloth, or damp chamois leather. Never use solvents.
- Make sure that you keep your set away from high temperatures.
- The use of apparatus in moderate climates.
- Do not be exposed to dripping or splashing, and that no object filled with liquids, such as vases,
shall be placed on the apparatus.
- No naked flame sources such as lighted candles should be placed on the apparatus.
Replacing the Fuse
Make sure the amperage matches the specified value when replacing the fuses. If the fuse is
blown, check the power connection and replace with a new one. If the same problem occurs,
it would be subjected to the malfunction in-house. In such cases, please consult the nearest
service dealer.
GB - 11
TROUBLE SHOOTING GUIDE
SYMPTOM
CAUSE
The car ignition switch is not
on.
No power.
The fuse is blown.
Presence of CD disc inside
the player.
Inserting the disc in reverse
direction.
D i s c c a n n o t
Compact disc is extremely
b e l o a d e d o r
dirty or detective disc.
ejected.
Temperature inside the car
is too high.
Condensation.
Volume is in minimum
No sound.
Wiring is not properly
connected.
The installation angle is
more than 30 degree.
Sound skips.
The disc is extremely dirty
or defective disc.
The built-in microcomputer
T h e o p e r a t i o n
is not operating properly
keys do not work.
due to noise.
The radio does not
The antenna cable is not
Work. The radio
connected.
station automatic
selection does not
The signals are too weak.
work.
SOLUTION
If the power supply is connected to
the car accessory circuits, but the
engine is not moving, switch the
ignition key to "ACC".
Replace the fuse.
Remove the disc in the player, put
a new one.
Insert the compact disc with the
label facing upward.
Clean the disc or try to play a new
one.
Cool off or until the ambient
temperature return to normal.
Leave the player off for an hour or
so and then try again.
Adjust volume to a desired level.
Check wiring connection.
Adjust the installation angle less
than 30 degree.
Clean the compact disc and then
try to play a new one.
Press the RES (reset) button.
Insert the antenna cable firmly.
Select a station manually.
GB - 12

Publicidad

Tabla de contenido
loading

Tabla de contenido