Setting The Clock; Operating The Radio - Metabo RC 14.4-18 Manual Original

Release cable clip and pull cable from rack rotationally.
3. Powered via DC IN socket
The radio can be also powered via the DC IN socket which can allow 9-14 Volt DC. This socket is
designed to be powered by the vehicle or the boat so you can take the radio with you outdoors or
on the boat. An additional cigarette lighter cable is required (not supplied) for this device.
Note:
Be carefully not to reverse the electrode +/- of the input DC power and not to input a voltage much
higher than 16V, otherwise that could damage inner circuitry.

Setting the clock

1. Clock can be set either the radio is power on or off .
2. Display will show "- : - -" when the batteries are installed or when the radio is connected to the
mains supply.
3. Press in Tuning control (Time Set) knob for more than 2 seconds, display will fl ash time set
symbol and also the hour digits, followed by a beep.
4. Rotary Tuning Control (Time Set) knob to set the required hours.
5. Press in Tuning control knob, the minute digits will fl ash.
6. Rotary Tuning Control button to set required minute.
7. Press in Tuning Control button to complete time setting.

Operating the radio

This radio is equipped with three tuning methods – Scan tuning, Manual tuning and Memory
presets recall.
Scan Tuning
1. Press the Power button to turn on the radio.
2. Select the required waveband by pressing the Band button. For FM band, be sure to screw in
the rubber FM antenna properly to get the best reception.
For MW (AM) band, rotate the radio to get the best signal, and turn off Charger switch on the
top to cut down charging battery function in order to minimise interference from electric circuit
when necessary.
3. Press and release Tuning Control /Time Set /Scan knob (long press the knob more than
2 seconds will activate time setting), the radio will up search and stop automatically when it
fi nds a radio station. Press the Scan button again to pick up the found station.
Note:
The radio will continue to search next available stations if you do not press Scan button again
when it fi nds a radio station.
4. Rotate the Volume Control and Tone Control to get required sound level.
5. To turn off the radio, press the Power button. Display will show OFF.
Manual tuning
1. Press the Power button to turn on the radio.
2. Select the required waveband by pressing the Band button. Adjust the antenna as described
above.
3. A single press on either rotate the Tuning Control knob will change the frequency in the
following increments:
FM: 50 or 100 kHz
MW (AM): 9 or 10 kHz
ENGLISH
ENG
21