Metabo RC 14.4-18 Manual Original página 22

ENGLISH
ENG
4. Rotate the Volume Control and Tone Control to get required sound level.
5. To turn off the radio, press the Power button. Display will show OFF.
Storing stations in preset memories
There are 5 memory presets for each waveband.
1. Press the Power button to turn on the radio.
2. Tune to required station using one of the methods previously described.
3. Press and release the required Preset button.
The preset number and station frequency will appear in the display.
4. Repeat this procedure for the remaining presets.
5. Stations stored in preset memories can be overwritten by following above procedures.
Recalling stations from preset memories
1. Press the Power button to turn on the radio.
2. Select the required waveband.
3. Momentarily press the required Preset button, the preset number and station frequency will
appear in the display.
Setting the radio alarm
When the radio alarm is selected, the radio will turn on and play the chosen radio station at
the chosen alarm time. The radio alarm will continue for one hour unless turned off by pressing
the Power button. Press the Power button whilst the alarm is activated will cancel the alarm for
24 hours.
Note:
Radio alarm can be activated only until both radio alarm time and radio alarmed station are set.
Radio alarm will be automatically switched to Buzzer alarm when the radio is in low battery status
or the selected radio alarm station signal is too weak.
a. Setting radio alarm time:
1. The radio alarm can be set either radio is on or off .
2. Press and release radio alarm button : the radio alarm signal will fl ash.
3. During radio alarm fl ashing, press Tuning control/Scan/Time Set knob for more than 2 seconds
followed by a beep tone.
4. Display Hour fl ashes. Rotate Tuning Control knob to select the hour then press in Tuning
control/Scan/Time Set knob again to confi rm hour setting.
5. Follow same procedure of setting hour to set required minute. Press Tuning Control/Scan/
Time Set knob again to complete alarm time setting.
b. Setting radio alarmed station:
1. During setting radio alarm time and radio alarm symbol is fl ashing, press Band button to
activate the radio to select required wake-up band and station by manual tuning and recall
preset stations.
2. When above radio alarm time and station are set, press and hold radio button
followed by a beep tone to switched alarm on or off . Display will show
is set.
Note: If new radio alarm station is not selected, it will select the last alarm station.
22
for 2 seconds
when radio alarm