Tabla de contenido
Publicidad
3. Upper casing
5. Control panel
I - low heating power
5B. Timer switch
7. An additional chain with carabiners at both ends of the chain
USE OF THE DEVICE
The device can be operated manually by pressing buttons on the control panel (5) or by using the remote control (6).
1. Assemble the device according to the instructions in the chapter: Before first use.
2. Connect the device to a power source.
3. To turn the device on, press the power button to position I. To turn the device off, press the power button to position 0 again. At first
start-up, the device defaults to low heating power.
4. To adjust the heating power level, press the 5A button on the control panel or on the remote control in sequence. The selected power
level is indicated by a red lamp on the control panel (5)
5. Use the 5B button on the control panel or the remote control to set the timer that will count down until the device turns off. By
pressing the 5B button successively, you will be able to set the working period from 1 to 7 hours in full hour increments and turn off the
timer. The selected period of operation of the device will be indicated on the control panel (5) by one green lamp for 1/2/4 hours (1H /
2H / 4H). The selected period of operation of the device will be signaled on the control panel (5) by lighting of two green lamps for 3/5/6
hours (1H + 2H / 1H + 4H / 2H + 4H). The selected period of operation of the device will be indicated on the control panel (5) by lighting
of three green lamps for 7 hours (1H + 2H + 3H).
CLEANING AND STORAGE
1. Before cleaning, always disconnect the heater from the wall socket and let it cool down.
2. Clean the outside of the device by wiping with a damp cloth and polish with a dry cloth.
3. Do not use any detergents or abrasives and do not let water get into the heater.
4. If the device is not used for a long time, protect it against dust and store it in a clean, dry place.
Technical data:
Power: 1900-2100W
Power supply 220-240V ~ 50Hz
Ip24
"Caution Hot Surface" - The temperature of accessible surfaces may be higher when the equipment is in operation, which
means that the housing elements become hot during operation during operation, BE CAREFUL !!!
WARNING: In order to avoid overheating - do not cover the heater
WARNING: Do not use this equipment near swimming pools or similar water tanks
To protect your environment: please separate carton boxes and plastic bags and dispose them in corresponding waste
bins. Used appliance should be delivered to the dedicated collecting points due to hazarsous components, which may
effect the environment. Do not dispose this appliance in the common waste bin.
II - medium heating power
4. Power switch
5A. Power switch:
III - high heating power
6. Remote control
8. Metal expansion bolt with hanging eye
Device is made in class II of insulation. Device is compliant with EU
directives:
- Low voltage directive (LVD)
- Electromagnetic compatibility (EMC)
Device marked CE mark on rating label
7
Publicidad
Tabla de contenido
