Ricatech RTT22 Manual Del Usuario página 5

ENGLISH
How To Replace the Stylus
Removing old stylus
1. Set a screwdriver at the tip of the stylus and push down to the
direction'A'
2. Remove the stylus by pulling it down and forward.
Installing a new stylus
1. Hold the tip of the stylus and insert the other edge by pressing
in the direction'B'.
2. Push up in the direction'C'until it locks at the tip.
PLAYING TURNTABLE
1. Press the POWER button to tum the unit on.
2. Select the SPEED CONTROL SWITCH to correct speed for the selected record.
3. Slide the LID LOCK towards to rear of the unit to open the lid.
4. Remove the protective plastic head. Remove the protective plastic head.
5. Lift the TONE ARM and gently move it to the right until it clicks into the ARM LOCK
as shown below:
6. Place the 45 rpm adapter on the spindle to play a 45 rpm record.
7. Place record on the turntable.
8. Gently move the tone arm from the ARM LOCK and lower it to the desired starting
point on the record: the needle at the bottom of the head is extremely delicate as
indicated in the warning label.
4