Parts And Maintenance - Ingersoll Rand 41 Serie Especificaciones Del Producto

EN
Clutch Adjustment
External
1. Rotate the External Adjustment Sleeve until opening in Housing is visible.
2. Rotate drive Spindle of Right Angle Housing until notch in Adjustment Washer is visible.
3. Insert No.1 Philips screwdriver in notch to turn gear teeth on Adjustment Nut.
4. Turning clockwise will decrease torque.
5. Turning counterclockwise will increase torque.
Internal
1. Remove Clutch Housing and Clutch Assembly from tool.
NOTICE
Clutch housing has left-hand threads.
2. With bit in Bit Holder, clamp bit in vise.
3. Clamp drive end of Driven Jaw in leather-covered or copper-covered vise jaws being
careful not to damage Driven Jaw.
4. Hold Clutch Assembly from turning. Then rotate Adjustment Nut with 7/8" wrench.

Parts and Maintenance

When the life of the tool has expired, it is recommended that the tool be disassembled,
degreased and parts be separated by material so that they can be recycled.
The original language of this manual is English.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll Rand Office or Distributor.
EN-2 80167398_ed1