Product Specifications; Installation And Lubrication - Ingersoll Rand 41 Serie Especificaciones Del Producto

Product Safety Information
Intended Use:
These tools are designed to remove and install threaded fasteners.
For additional information refer to Product Safety Information Manual Form
04585006.
Manuals can be downloaded from www.irtools.com.

Product Specifications

Model(s)
41AA6LTH4
41AA9LTH4
41AA16LTH4
41AA24LTH4
41AA6LTS6
41AA9LTS6
41AA16LTS4
41AA24LTS4

Installation and Lubrication

Size air supply line to ensure tool's maximum operating pressure (PMAX) at tool inlet. Drain
condensate from valve(s) at low point(s) of piping, air filter and compressor tank daily.
Install a properly sized Safety Air Fuse upstream of hose and use an anti-whip device
across any hose coupling without internal shut-off, to prevent hose whipping if a hose fails
or coupling disconnects. See drawing 16585820 and table on page 2. Maintenance
frequency is shown in circular arrow and defined as h=hours, d=days, and m=months.
Items identified as:
1. Air filter
2. Regulator
3. Lubricator
4. Emergency shut-off valve
5. Hose diameter
6. Thread size
80167398_ed1
Clutch
Type
Auto shut off
Auto shut off
Auto shut off
Auto shut off
Auto shut off
Auto shut off
Auto shut off
Auto shut off
7. Coupling
8. Safety Air Fuse
9. Oil
10. Grease - through fitting
11. Grease (disassembly required, see
maintenance instructions)
Drive
Type size
Hex 1/4"
Hex 1/4"
Hex 1/4"
Hex 1/4"
Square 3/8"
Square 3/8"
Square 1/4"
Square 1/4"
EN
Free Speed
rpm
600
900
1,600
2,400
600
900
1,600
2,400
EN-1