Honeywell HW100 Instrucciones Y Advertencias página 21

Adjustable Shades 9-13 ADF Model: HW200
AUTO DARKENING
SHADE 4/9-13
3
Model: HW200
XA-1010(I) Pro
5
7
6
4
1. Solar cell
2. Photo–sensor
3. Filter Housing
4. Liquid crystal active
light filter
Only operate HW200 ADF at temperatures between -10°C to + 55°C (+14°F to+131°F), HW100 ADF
at temperature between -5°C to + 55°C (+23°F to+131°F). If used outside of this range, the filter
may not perform as designed and may result in permanent eye injury and vision loss. Check the
recommended shade protection for specific welding process and select the recommended shade
(Figure 1).
Adjustment of Sensitivity (for HW200): Most welding applications can be performed with welding
light sensitivity set to maximum. The maximum sensitivity level is appropriate for low welding current
work, TIG, or special applications. The light sensitivity is reduced only in specific surrounding lighting
conditions, in order to avoid unwanted triggering. It is recommended to set the sensitivity to the
maximum, and then gradually reduce it, until the filter reacts only to the welding light flash and
without annoying false triggering due to ambient light conditions (direct sun, intensive artificial light,
neighboring welder's light flash, etc.)
GB_AU_NZ-6
Tigerhood Book.indb 6
8
4/9-13 CSS 1/1/1/2/379
1
ANSI CSS Z87 W4/9-13
10
2
2
9
3
4
5. Shade adjustment
6. Opening time delay
adjustment
7. Sensitivity adjustment
8. Low battery LED
9. Grind mode switch
10. Grind mode LED
3/14/13 4:36 PM