Metabo PL 5-30 Instrucciones página 9

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 28
Commissioning
The instrument is switched on with the on/off switch (1). The side exit
aperture (3a) is uncovered at the same time for a horizontal laser beam.
By moving the sliding cover (5) the exit aperture (3b) is uncovered for a
further horizontal laser beam.
Place the laser on a level surface. The laser must be within its ±4,5°
self-levelling range for it to align automatically.
Positioning the laser and transferring points
Plumb line function:
Release the release lever (7), extend the foot (6) and lock into position.
The PL 5-30 is positioned and switched on -> switch (1).
The down laser beam is aligned on the object or mark as required.
Mark the position of the perpendicular laser beam on the ceiling.
Please note that the centre of laser dot is marked !
Plumbing a Wall
Release the release lever (7), extend the foot (6) and lock into position.
Position the laser in such a way that the foot (6) is on the front edge of
the floor profi le.
Switch on the instrument. -> switch (1 ).
Illuminated green LED (2) -> laser in operation.
Align the upper end of the partition wall until the perpendicular laser beam
meets the upper edge of the top track.
Operating status display and error messages
Illuminated green LED
Illuminated red LED
laser beam flashing->
Replacing the batteries
Slide the battery cover (4) in the direction of the arrow and insert new
batteries in accordance with the symbols in the battery compartment.
Suitable batteries can also be used.
Checking the calibration
The PL 5-30 5 point laser is designed for use on construction sites and left
our factory perfectly adjusted.. As with any precision instrument, however,
its calibration must be regularly checked. The unit should be checked
before starting any new tasks, particularly when the unit has been exposed
to strong vibrations.
-> laser in operation
-> battery voltage very low
-> The unit is inclined too much
+ is outside the self-levelling range
+ the laser cannot level itself automatically
en
via the LED
B1
B2
B3
B4
B5
D1
D2
D3
D4
D1
D2
D3
D4
D5
C
9

Publicidad

Tabla de contenido
loading

Tabla de contenido