Electrical Safety; Safety Instructions - Worksite BG106 Traducción Del Manual Original

BENCH GRINDER
WARNING
Read this manual carefully before using the
machine, for your own safety.

SAFETY INSTRUCTIONS

When using the machine, always observe
the enclosed safety instructions as well as
the additional safety instructions.
The following symbols are used throughout
this manual:
Denotes risk of personal injury
or damage to the tool.
Take measures to protect your
eyes.
Consult the manual.
ADDITIONAL SAFETY INSTRUCTIONS FOR
BENCH GRINDERS
Always wear safety goggles while grinding.
I
Keep children out of the work area.
I
Never operate the grinder without the
I
wheel guard in place.
Always securely fix the workpiece support.
I
The distance between the spark guard and
I
the grinding wheel must not exceed 2 mm.
The distance between the workpiece
I
support and the grinding wheel must not
exceed 2 mm.
Never use damaged grinding wheels.
I
Replace the grinding wheel when it has
I
worn by more than approx. 40 mm.

ELECTRICAL SAFETY

Always check that the power
supply corresponds to the
voltage on the rating plate.
DESCRIPTION (fig. A)
Your bench grinder has been designed for
sharpening knives, chisels and other cutting
tools.
1 On/off switch
2 Grinding wheel
3 Wheel guard
4 Spark guard
5 Transparant screen
6 Workpiece support
7 Adjusting screw
8 Mounting hole
9 Mounting screw for spark guard
10 Nut
Mounting the machine (fig. A)
The machine must be screwed to a
workbench.
Mark the position of the mounting holes (8)
I
on the workbench.
Drill holes at each of the marked
I
positions, adjusting the diameter and
depth of the holes to the screws used.
Place the machine on the workbench and
I
insert the screws into the mounting holes.
Firmly tighten the screws.
I
Replacing a grinding wheel (fig. A & B)
Remove the wheel guard (3).
I
Loosen the nut (11). The nut on the right
I
spindle has a right thread, the nut on the
16