Cleaning And Maintenance; Technical Data - Worksite BG106 Traducción Del Manual Original

left spindle a left thread.
Remove the outer flange (12) and the old
I
grinding wheel (2).
Clean the flanges (12 & 13).
I
Place a new grinding wheel.
I
Place the outer flange against the grinding
I
wheel and place the nut onto the spindle.
Securely tighten the nut.
Replace the wheel guard.
I
Always unplug the tool before
replacing a grinding wheel.
Never use a cracked grinding
wheel. Immediately replace a
cracked grinding wheel. A cracked
grinding wheel may break into
pieces when used and cause
accidents.
Mounting and adjusting the spark guards
(fig. A)
You must regularly adjust the spark guards
in order to compensate the wear of the
grinding wheels.
Mount the spark guard (4) to the wheel
I
guard (3) using a screw (refer to the figure).
Adjust the distance between the spark
I
guard and the grinding wheel (2) to the
smallest possible value, with a maximum
of 2 mm.
Tighten the spark guard.
I
Slide the screen (5) to the front.
I
Tighten the nut (10).
I
The spark guard protects your
eyes and hands from sparks flying
from the workpiece. Therefore,
always use the spark guard.
Adjusting the workpiece supports (fig. A)
You must regularly adjust the workpiece
supports in order to compensate the wear of
the grinding wheels.
Loosen the adjusting screw (7).
I
Adjust the distance between the
I
workpiece support (6) and the grinding
wheel (2) to the smallest possible value,
with a maximum of 2 mm.
Tighten the adjusting screw.
I
Instructions for use
Before switching on the machine, check if
I
all screws and nuts are tight and if the
grinding wheel can rotate freely.
Always grind on the front part of the
I
grinding wheel. Never overcharge the
machine, causing the grinding wheel to
come to a halt.
The machine is not intended for
I
permanent use. Make sure that the
machine is not overheated. After using the
machine for 30 minutes, let it cool down
to ambient temperature.
Switching on and off (fig. A)
To switch the machine on, set the on/off
I
switch (1) to 'I'.
To switch the machine off, set the on/off
I
switch (1) to '0'.

CLEANING AND MAINTENANCE

The machine does not require any special
maintenance.
Regularly remove grindings from the
I
housing and the covers.

TECHNICAL DATA

Mains voltage
Mains frequency
Power input
No load speed
Max. thickness grinding wheel mm 16
Diameter grinding wheel
17
V 230
Hz 50
W 200
min -1 2,840
mm 150