In The Event Of Problems - Rowenta REFLEXSPA TS8050F0 Manual De Instrucciones

TS8051F0_1800117679_reflexspa 27/05/10 14:52 Page10

6- IN THE EVENT OF PROBLEMS

Problem
• The carpet of balls does not
move by itself.
• Your REFLEXSPA does not
®
produce air bubbles of air.
• The appliance moves during • It is not on a flat surface.
operation.
• The reflexology, digipression • You are pressing too hard,
or exfoliation accessory is
blocked (according to model)
• The water seems too hot
• The rotating accessories
are moving in a jerky way,
or the rotation changes
direction.
• Some water drops appear
under your appliance.
• Your accessories are moving • You did not fully insert the accessories.
when you fill up your
REFLEXSPA with water.
®
7- LET US PARTICIPATE IN ENVIRONMENTAL PROTECTION!
Your appliance contains many materials which may be valuable or which can be recycled.
Send it to a collection point or an approved service centre so that the treatment can be carried out.
Explanation
• It is normal: they are not powered and are involved only by the movement
of the foot.
• You have perhaps used an
additive which has blocked
the holes.
• It is lacking a shoe.
it has disengaged for safety.
• You have filled your appliance
with water which is too hot.
• You are pressing too hard.
• The water drops can appear after
rinsing unless handled gently.
Proposed solution
• Clear the bubble diffusion holes with
a needle, then start the REFLEXSPA
very hot water to dissolve the thick
matter. Do not put your feet in it.
• Put it on a horizontal surface.
• Contact your after sales service to add
the missing shoe.
• Place your foot on the accessory gently.
If the problem persists, contact after sales
service.
• Fill it again with cooler water.
• Try to fill your appliance with water
which is adapted to you.
• Don't press so hard.
If the problem persists, contact after sales
service.
with
®