Publicidad
Enlaces rápidos
Read And Save These Instructions
Evaporative cooling is an economical way to cool. Air is cooled while being drawn across wet evapora-
tive media. The movement of this fresh cooled air over the skin is what makes it feel cool. It is important
when using an evaporative cooler in an enclosed space to have adequate exhaust by opening windows,
doors, etc. Without an outlet to exhaust the air, humidity will build up in the enclosed space and the
unit will not cool adequately. It is preferable to have an opening behind the unit to bring in fresh air and
another opening accross the room to exhaust and help move the air.
1. Unit must be in the Off Position and Unplugged from power receptacle when performing any mainte-
nance.
2. To reduce the risk of electric shock, plug unit into a properly grounded 120 Volt A.C., 60 Hz receptacle.
3. To reduce the risk of electric shock, install only on a circuit protected with a Ground Fault Circuit Inter-
rupter (GFCI).
WARNING: To reduce the risk of fire or electric shock, do not use this fan with any "solid-state
fan speed control device."
110489-3
12/08
Portable Evaporative Cooler
CP35
Evaporative Cooling
Safety Rules
Champion Cooler
5800 Murray St.
Little Rock, AR 72209
www.championcooler.com
CP65
Publicidad
Manuales relacionados para UltraCOOL CP35
Resumen de contenidos para UltraCOOL CP35
- Página 1 Portable Evaporative Cooler CP35 CP65 Read And Save These Instructions Evaporative Cooling Evaporative cooling is an economical way to cool. Air is cooled while being drawn across wet evapora- tive media. The movement of this fresh cooled air over the skin is what makes it feel cool. It is important when using an evaporative cooler in an enclosed space to have adequate exhaust by opening windows, doors, etc.
- Página 2 Cooler Installation Install Casters This unit comes equipped with 4 stem casters; 2 locking and 2 non-locking. Before operation turn the unit on its side and press the stem casters into the corner holes. Install the locking caster on one side of the unit and the non-locking casters on the opposite side.
- Página 3 Maintenance WARNING: Before doing any maintenance be sure unit is unplugged. Drain Unit Note: To remove the media frame, first remove the screw located above the frame. To drain the unit, remove the media frame and remove the rubber drain stopper from the bottom of the unit by pulling it out of the drain hole.
-
Página 4: Replacement Parts
• Check that unit is plugged into a 120V power receptacle. • Check the fuse or breaker. • If connected to a GFCI outlet, check if it is tripped. Replacement Parts Description CP35 CP65 Evaporative Media............110132-1 110132-2 Evaporative Media Frame Assembly......110870-1 110870-2 Set Of (4) Keepers ............110871...