HQ-Power VDPDP1N Manual Del Usuario página 5

b) Switchpack Mode
1. When the DMX address has been set press the MENU button to enter the next level.
2. Tap the DOWN button; the segment display shows "s---".
3. Press the MENU button to enter switchpack mode. This mode consists of switching on (S-on)
and switching off (S-of). In the switch-on mode, the output is turned off and the fixture is
controlled by DMX signal. When the DMX level is less than 40%, the fixture goes out; when the
DMX level exceeds 40%, the fixture is on.
4. Tap the UP or DOWN button to change between switch ON and OFF.
5. Once the switchpack is selected, press the MENU button to return to the DMX address mode.
c) Dimmer Pack Mode
1. Press the MENU button to enter the next level.
2. Tap the UP button; the segment display shows "d---".
3. Press the MENU button to enter the dimmer limit mode.
4. Tap the UP or DOWN button to change the value within the range of 30-100. Each tap will
change the value once. Holding the button pressed will change the value quickly. Once the
dimmer limit is selected, it will be stored automatically.
5. Press the MENU button to enter dimmer preset mode.
6. Tap the UP or DOWN button to change the value within the range of 00-100. Once the dimmer
preset is selected, it will be stored automatically.
7. Press the MENU button to return to the DMX address mode.
VDPDP1N 5 HQPOWER