Setup And Operation - DJ-Tech Conrad 30 49 62 Manual De Instrucciones

3

SETUP AND OPERATION

Accessory the turntable
Fig. a
Motor spindle
Red ribbon
Drive belt
1. Carefully place the turntable platter on the center spindle, making certain the platter is fully seated
on the spindle.
2. While holding both ends of the red tape ribbon on the turntable belt, carefully pull the belt over the
motor pulley (Fig. a).
3. Once the belt is seated in the pulley's groove, carefully remove the ribbon. Make certain the belt is
not twisted
4. Place the slipmat on top of the turntable platter (Fig. b).
5. If desired, the hinged dust cover may be removed. Hold both sides of the dust cover and pull upward
gently and evenly to detach the cover from the turntable (Fig. c).
6. To re-install the dust cover, guide the dust cover hinges into the two hinge receptacles located at the
back of the turntable housing.
Setting the Pre-amp (Phono/Line) switch
The Phono/Line switch is located on the back of the turntable. (Fig. d)
• If the stereo system you are using has a PHONO input, set the pre-amp selector switch to the
"PHONO" position.
• If your stereo system does not have a PHONO input, set the pre-amp selector switch to the "LINE"
position and connect the turntable's output cables to the AUX or other high-level input on your stereo
system.
Connect the cable with the white plug to the (L) jack and red plug to the (R) jack.
Connect the power cord plug to an AC outlet.
Fig. d
Input
Jacks
Pre-amp
Selector
Switch
Fig. b
AUX PHONO
LINE
PHONO
Stereo System
White
Red
5
Fig. c
AC
AC