Stiga SE 1814 Q Manual De Instrucciones página 30

10
EN
1. CHECKS DURING WORK
• Checking the chain tension
The chain tends to stretch gradually as you work,
so you need to check its tension frequently.
IMPORTANT
(or after replacing the chain), it must be checked
more frequently due to settling of the chain.
WARNING!
loose, as it can be hazardous if the chain slips
out of its guides.
To adjust the chain tension, follow the instructions
in Chapter 5.2.
• Checking the oil delivery
IMPORTANT
out lubrication! You can check the oil level in the
tank through the transparent gauge. Make sure
you fill up the oil tank every time you use the ma­
chine.
WARNING!
chain are in place when you check the oil de­
livery.
Start the engine and check if the chain oil is de li -
vered as shown in the figure (Fig. 13).
• Shutdown whilst working (Only for
C 2.2 E/ET – SE 2216 / 2216 Q - A 220 EQ)
Your chain saw is designed with an overload
protection with circuit breaker. If the chain saw is
clogged (e.g. blocking of the cutting means, chain
teeth jammed, overload cutting) during the cutting
operation, the overload circuit breaker will cut the
mains power supply automatically to protect your
chain saw.
IMPORTANT
activated when the cutting current is over 35­40A,
and it can be reset manually by pressing the reset
button (1.15) 30 seconds after it has cooled com­
pletely.
During the first period of use
Never work with the chain
Never use the machine with­
Make sure the bar and the
The circuit breaker will be
2. DIRECTIONS FOR USE AND CUTTING
TECHNIQUES
Before felling or delimbing for the first time, prac-
tise sawing logs on the ground or on trestles, so
that you can get familiar with the machine and the
most suitable sawing techniques.
WARNING!
with both hands when sawing.
WARNING!
tely if the chain stops during sawing. Be wa re
of kickback, which can occur if the bar con­
tacts an obstacle.
• Felling a tree
– When bucking and felling operations are being
performed by two or more persons at the sa me
time, the felling operations should be separated
from the bucking operation by a distance of at
least twice the height of the tree being felled.
Trees should not be felled in a man ner that
would endanger any person, stri ke any utility
line or cause any property damage. If the tree
does make contact with any u ti lity line, the com-
pany should be notified im mediately.
– The chain saw operator should keep on the up-
hill side of the terrain as the tree is likely to roll
or slide downhill after it is felled.
– An escape path should be planned and clea-
red as necessary before cuts are started. The
e scape path should extend back and diagonally
to the rear of the expected line of fall as illus-
trated in Figure 15.
– Before felling is started, consider the natural
lean of the tree, the location of larger branches
and the wind direction to judge which way the
tree will fall.
– Remove dirt, stones, loose bark, nails, staples
and wire from the tree.
• Notching undercut
Make the notch 1/3 the diameter of the tree, per-
pendicular to the direction of falls as illustrated in
Figure 16.
Make the lower horizontal notching cut first.
his will help to avoid pinching either the saw chain
or the guide bar when the second notch is being
made.
USING THE MACHINE
Always hold the machine
Stop the engine im me dia­