5450700-i-light-man_b 31.08.10 11:00 Seite 27
Switching on the lamp
Press the on/off switch (2).
Switching off the lamp
Press the on/off switch (2) again.
Setting the working position
The LED battery lamp can be
used as a hand-held or standing
lamp. The lamp can also be
suspended at a suitable point by
the hanger (5). For better lighting,
the lamp head (1) can be
swivelled fully through 145°
(Fig. 3).
CAUTION! At low
temperatures, the light
yield and lighting time may be
reduced. This is due to the
temperature, and is not a
malfunction.
When the lighting power begins
to decline, recharge the battery.
8 – Maintenance and
environmental
protection
Clean the case only with a damp
cloth – Do not use solvents! Then
dry well. To maintain capacity, we
recommend completely
discharging and recharging the
battery every two months. Store
only fully charged batteries. They
should therefore be recharged
from time to time. The place of
storage must be dry; the ambient
temperature must not fall below
0 °C or rise above 40 °C.
CAUTION! Electrical and
battery operated units that
no longer work should not be
disposed of in the household
waste! They are to be collected
separately, in accordance with the
2002/96 EC directive
for the disposal of
electrical and
electronic waste,
and sent for proper
and environmentally-
friendly recycling.
ATTENTION! Batteries
must be removed from
battery-powered tools and
disposed of separately in
accordance with relevant waste-
battery regulations. Batteries
must never be disposed of with
domestic waste!
Please discard power tools no
longer usable at a local
collection point. Collection and
disposal of packaging materials
separately by types complying
with local rules and regulations.
For details, please contact your
municipal authority concerned.
9 – Service instructions
• Meister devices are to a large
extent maintenancefree, a
damp cloth being sufficient to
clean the casing. Please note
additional hints given in the
operating instructions.
• Meister devices are subject to
stringent quality control. If
however a functional fault shoult
occur, send the device to our
27