Promise VTRAK M610p Guia De Inicio Rapido página 14

VTrak M610p Quick Start Guide
prevent the DHCP server from assigning a new IP address when the VTrak
restarts, with the result that users can no longer log in.
To access the MAC address for VTrak's management port:
• In the CLI, type net -v and press Enter.
• In the CLU Main Menu, highlight Network Management and press Enter.
Then highlight the Mgmt port in the list and press Enter.
Setting up with the CLI
1. Type the following string to set the system date and time, then press Enter.
administrator@cli> date -a mod -d 2006/12/26 -t 14:50:05
In the above example, the date and time are included as examples only.
Your values will be different. Use yyyyy/mm/dd for the date and a 24-hour
clock for the time.
2. Type the following string to set the Management Port IP address and other
settings, then press Enter.
administrator@cli> net -a mod -t mgmt -s "primaryip=192.168.10.87,
primaryipmask=255.255.255.0, gateway=192.168.10.3"
In the above example, the IP addresses and subnet mask are included as
examples only. Your values will be different.
If you prefer to let your DHCP server assign the IP address, type the
following string, then press Enter.
administrator@cli> net -a mod -t mgmt -s "dhcp=enable"
3. To verify the settings, type net and press Enter.
administrator@cli> net
===========================================
CId Port Type
===========================================
1
This completes the Management port setup. Go to "Step 8: Creating Disk Arrays
with WebPAM PROe" on page 17.
To see the full set of CLI commands, at the admin@cli> prompt, type help and
press Enter.
IP
1 Mgmt 192.168.10.87 255.255.255.0 192.168.10.1
Mask
14
Gateway Link
Up