Set-Up - Tetra LightWave Timer Instrucciones

Function during operation
Function in set-up mode
Description
•
Reduce the brightness of the LED light.
Not possible if an effect is enabled.
•
Start set-up mode.
SET
Press and hold the button for 3 seconds.
•
Save settings and navigate to the next menu.

SET-UP

Procedure:
Press and hold SET for 3 seconds to open the set-up menu.
• The set-up order is pre-determined: A | Current time
off time of the LED light
derstorm.
• The menu is exited automatically after 30 seconds of inactivity.
Set-up menu
A Current time.
• The figures flash on the display.
1. Set the current time using the HOUR and MINUTE buttons.
2. Press SET to save the setting.
3. Press SET again to switch to menu item B.
B Switch-on/switch-off time of the LED light (daytime phase).
• "ON" (switch-on time) is briefly shown on the display, followed by the
time.
1. Set the switch-on time using the HOUR and MINUTE buttons.
2. Press SET to save the setting.
– "OFF" (switch-off time) is briefly shown on the display, followed by
the time.
3. Set the switch-off time using the HOUR and MINUTE buttons.
4. Press SET to save the setting and switch to menu item C.
C | Sunrise/sunset
B | Switch-on/switch-
D | Cloudy sky E | Thun-
UK
9