Assembly And Installation - Uline H-4377 Guia De Inicio Rapido

16
17
10
1. Check to see if all parts are included.
2. Screw discharge spout (9) into pump body (1) outlet
using PTFE sealant tape provided.
CAUTION! Do not use pipe sealant.
3. In order to avoid leakage, use PTFE sealant tape
(included) to seal three suction tubes (20) with two
tube connectors (21).
4. Attach bung adapter (19) onto the top of the
assembled suction tube. Screw assembled suction
tube into pump body (1).
PAGE 2 OF 6

ASSEMBLY AND INSTALLATION

14
18
13
5
4
8
3
11
2
15
12
1
7
6
5
20
21
5. Insert handle shaft (17) through handle (16). Turn hex
nut (18) onto handle shaft until handle rotates freely.
6. Screw assembled handle to crank arm (14). Keep
handle shaft from turning. Tighten hex nut (18)
against crank arm. Then insert crank arm assembly
onto rotor (4), taking care to align set screw (15) to
indent in rotor shaft.
7. Insert assembled pump into drum and hand tighten
the fixed screw onto bung adapter (19). Be sure to
set pump and assembled suction tube so that the
suction tube is at the desired depth in the drum and
is not blocked.
1-800-295-5510
uline.com
# DESCRIPTION
9
1 Pump Body
2 Rear Cover
3 Front Cover
4 Rotor
5 Vane
6 Spring
7 Spring Rod
8 Lip Seal
9 Discharge Spout
19
20
10 Cap Screw
11 Cap Screw
12 O-Ring
13 Hex Bridge
14 Crank Arm
15 Set Screw
16 Handle
17 Handle Shaft
18 Hex Nut
19 Bung Adapter
20 Suction Tube
21 Tube Connector
22 Suction Filter
22
QTY.
1
1
1
1
2
1
1
1
1
4
6
2
2
1
1
1
1
1
1
3
2
1
0721 IH-4377