Device Overview; Front View; Bottom View - Samoa U-power Manual Del Usuario

EN
INTRODUCTION
WARNING: This unit is intended to professional use. Read the instructions in this manual before using the device.
!
• The U·Power or U·power+ unit is intended to work as a power supply for the equipments of a monitoring system.
• Use the equipment only for the purposes for which it is intended.
• Do not alter or modify the equipment.
• Any failure of the equipment must be examined by a qualified technician. Do not remove the housing from the power
supply due to risk of damage by electrical contact.
• Do not install the equipment in places with high humidity or near water.
• Do not install this equipment in places with a high environmental temperature or near a heat source.
• The current and voltage values must not exceed those given in the technical specifications.

DEVICE OVERVIEW

FRONT VIEW

Nº ITEM
1 CAN BUS 1/BUS IN
2 CAN BUS 2/BUS OUT CAN BUS out connection
3
By-pass keyswitch
4 IEC connector

BOTTOM VIEW

Nº ITEM
Technical
1
specifications
2 Assembly holes
2
838 853 R. 10/18
SAMOA Industrial, S.A. · Pol. Ind. Porceyo, I-14 · Camino del Fontán, 831 · 33392 - Gijón - Spain · Tel.: +34 985 381 488 · www.samoaindustrial.com
DESCRIPTION
CAN BUS in connection
Allows the activation of
by-pass mode
Power supply inlet
DESCRIPTION
Main technical features of
the equipment
Assembly holes
1 3
4
1
2
2
Fig. 1
Fig. 2