Installation And Configuration - Samoa U-power Manual Del Usuario

INSTALLATION AND CONFIGURATION

For further details about the installation and configuration of the equipment, check the monitoring system "Installer's
Guide".
DEVICE ATTACHMENT
Optionally, the device can be fixed by using the assembly
holes (1).
DATA BUS CONNECTION
1. Strip the end of the CAN Bus cable according to the
scheme shown in the figure 4.
2. Connect each wire of the CAN BUS cable to the 5 poles
male plug connector by using the following schematic
in the figure 5.
3. Hold the wire to the provided housing by screwing the
retaining plate (2) and closing the housing.
4. To avoid the accidental disconnection of the CAN BUS
connectors, remember to fix them by using the two
safety screws available.
DATA BUS CONNECTION
Wire the supplied IEC connector (3). To avoid the
accidental disconnection of the equipment, remember to
place the retention kit (4) in the position shown in the
figure 3.
BY-PASS KEYWITCH
The by-pass key allows to activate / deactivate the by-pass
mode of the solenoid valves powered by the U·power unit.
The activation allows dispensing fluid without the need of
using the keyboard, just simply by using the control gun.
SAMOA Industrial, S.A. · Pol. Ind. Porceyo, I-14 · Camino del Fontán, 831 · 33392 - Gijón - Spain · Tel.: +34 985 381 488 · www.samoaindustrial.com
3
1
4
2
R. 10/18 838 853
EN
Fig. 3
Fig. 4
Fig. 5
3